Table of Contents
Advertisement
A
K
7
7
-
8
X
M
a
x
A
K
7
7
-
8
X
M
a
x
*************************************************
Installing Driver in Existing Windows 2000 System
*************************************************
WARNING: If you will be moving the boot drive containing the existing Windows 2000 operating system to the SATA150
connector, the SATA150 driver MUST be loaded on to this hard drive while it is still attached to your existing hard drive controller.
Do not attach this drive or any other hard drive to the SATA150 connector before completing this step.
After enabling the SATA150 IDE controller and rebooting your system, Windows 2000 setup will show a "New Hardware Found"
dialog box. Under Windows 2000, "PCI Mass Storage Controller" will be displayed.
1. Choose "Search for a suitable driver for my device (Recommended)". from the list, and
then press "Enter".
2. Choose "Specify a location." and then press "Next"
3. Choose "Mass Storage controller" and press "next" and next screen press "finish"
4. Insert the Promise SATA150 driver diskette into drive A:.
5. Type "A:\" in the text box that appears. Press " OK ".
4a. Insert the Bonus CD in CD-ROM.
5a. Type "[CD-ROM]:\Driver\Promise\SATA150\Driver\Win2000" in the text box that appears. Press " OK ".
6. Click on "Next." A message informing you that Windows has found "Win2000 Promise SATA TX2plus (tm) IDE Controller"
should appear.
7. Click on "Next," and then on "Finish."
************************************
Confirming Windows 2000 Installation
************************************
1. From Windows 2000, open the Control Panel from "My Computer" followed by the System icon.
2. Choose the "Hardware" tab, and then click the "Device Manager" tab.
3. Click the "+" in front of "SCSI controllers". "Win2000 Promise SATA TX2plus (tm) IDE Controller" should appear.
94
O
n
l
i
n
e
M
a
n
u
a
l
O
n
l
i
n
e
M
a
n
u
a
l
Advertisement
Table of Contents
