Table of Contents
Advertisement
A
K
7
9
G
M
A
X
/
A
K
A
K
7
9
G
M
A
X
/
A
K
NOTE: If you need to specify any additional devices to be installed, do so at this time. Once all devices are specified, continue
to the next step.
7. From the Windows NT Setup screen, press the Enter key. Setup will now load all device files and then continue the Windows
NT installation.
8. After a successful installation, the "SCSI Adapter Setup" box will show that the "WinNT Promise SATA TX2plus (tm) IDE
Controller" driver has been installed.
*****************************************************
Installing Drivers with Existing Windows NT 4.0
*****************************************************
WARNING: If you wish to use your current bootable drive with the Windows NT4 operating system on the SATA150, perform the
steps below while the boot drive is still attached to your existing onboard IDE controller. Do not attach any drives to
your SATA150 until the steps below are complete.
1. Choose "Settings" from the "Start" menu.
2. Choose "Control Panel" from the "Settings" menu.
3. Double-click on the "SCSI Adapters" icon, which generates the "SCSI Adapters" dialog box.
4. Choose "Drivers," and then press "Add."
7
9
D
M
A
X
7
9
D
M
A
X
86
O
n
l
i
n
e
M
a
n
u
a
l
O
n
l
i
n
e
M
a
n
u
a
l
Advertisement
Table of Contents
