Advertisement
After installing 3D Blaster GeForce2 GTS and starting your system, the monitor
displays a blank screen.
Solutions
Try the following:
Switch off your system and wait a while before switching it on again.
Verify that any built-in VGA on your motherboard is disabled and that you
have removed any other video display card from your system.
Ensure that your 3D Blaster GeForce2 GTS card's bus connector is fully
inserted into the expansion slot. Ensure this by pressing it gently and evenly
into the slot.
Verify that the pins of your monitor's VGA Input connector are not bent and
that the connector is properly connected to the VGA Out connector of 3D
Blaster GeForce2 GTS.
In a multi-monitor setting, the monitor connected to the 3D Blaster GeForce2 GTS card
remains blank even though the card and its drivers have been installed.
Cause
If 3D Blaster GeForce2 GTS's drivers are not specified during the software
installation, the system installs it as a standard VGA card that does not support
Windows 98's multi-monitor feature.
Solution
Update the device drivers to 3D Blaster GeForce2 GTS's drivers:
1. Right-click your desktop, and then click Properties on the shortcut menu.
2. In the Display Properties dialog box, click the Settings tab.
3. On the Settings tabbed page, click the Advanced Properties button.
4. In the Advanced Display Properties dialog box, click the Change button.
5. In the Select Device dialog box, click the Have Disk button.
6. Insert the 3D Blaster GeForce2 GTS CD into your CD-ROM drive.
3D Blaster GeForce2 GTS Installation Guide 21
Advertisement
