Replacing The Stylus Tip; Installing A Stylus Tether - Fujitsu STYLISTIC Q584 Operating Manual

Replacing the stylus tip

With use, the stylus tip may become worn or may pick up foreign particles that can scratch the screen.
A damaged or worn tip may not move freely, causing unpredictable results when using the stylus.
If your stylus exhibits these problems, replace the stylus tip. To do this, use the supplied tool (1).
If the tip is worn or damaged, discard it.

Installing a stylus tether

Attach the stylus with a stylus tether to prevent accidentally dropping it or losing it.
► Fasten the stylus tether to the stylus eyelet and to the eyelet on the Tablet PC.
Fujitsu
1
Working with the Tablet PC
► To remove the tip, position it in the gap
between the two ends of the tool supplied.
► Pinch the two ends of the supplied tool
together so that the tip is firmly clasped,
then pull it from the barrel.
► Replace the tip with one of the new tips
that were supplied with your stylus. Insert
the flat end of the tip into the barrel
and exerting gentle pressure, push it
in until it is firmly in place.
33