Acoustic Warning; Error Messages On The Screen - Fujitsu STYLISTIC Q584 Operating Manual

Troubleshooting and tips

Acoustic warning

Errors Acoustic warnings
Cause
A beep sounds every few seconds.
The battery is almost flat.

Error messages on the screen

Errors Error messages onthescreen
This section describes the error messages generated by the BIOS Setup. Error messages displayed
by the operating system or programs are described in the documentation for these programs.
If the error message appears repeatedly despite troubleshooting measures,
contact the place of purchase or our customer service center.
Error message/cause
CMOS Battery Bad
If the error message occurs repeatedly, the
buffer battery in the Tablet PC is flat.
System CMOS checksum bad - Default configuration
used
The system configuration information is
incorrect.
Extended memory failed at offset: xxxx Failing Bits:
zzzz zzzz
When testing the extended memory. an error
has resulted at the address xxxx.
Failure Fixed Disk n
The settings of the hard disk drive are incorrect.
Keyboard controller error
Keyboard error
nn Stuck key
76
Troubleshooting
► Charge the battery.
Troubleshooting
► Contact your sales outlet or our customer
service center.
► Switch the Tablet PC off.
► Switch the Tablet PC on.
► Keep the volume button and the shortcut
button pressed and switch the Tablet PC
on. If you keep the volume button pressed
during the boot process, you can switch into
the BIOS Setup-
► In the BIOS Setup, select the Exit menu.
► Select the entry Load Setup Defaults.
► Select OK and press the Enter key.
► Contact your sales outlet or our customer
service center.
► Start the BIOS Setup (Primary Master
submenu) and select the correct settings.
► Switch your Tablet PC off with the ON/OFF
button.
► Wait 3 - 5 seconds and switch the Tablet PC
on again.
If you use an external keyboard:
► Check the connection and reboot the Tablet
PC.
► Make sure that no key is pressed.
Fujitsu