Table of Contents
Advertisement
5. Connecting Front Panel Cable
Attach the power LED, speaker, and reset switch connectors to the
corresponding pins. If you enable "Suspend Mode" item in BIOS Setup, the
ACPI & Power LED will keep flashing while the system is in suspend mode.
Locate the power switch cable from your ATX housing. It is 2-pin female
connector from the housing front panel. Plug this connector to the soft-power
switch connector marked SPWR
6. Connecting ATX Power Cable
. This motherboard comes with a 24-pin ATX power connector and a 4-pin 12V
ATX power connector as shown below. Make sure you plug in the right direction.
We strongly recommend you to insert the 4-pin connector before connecting the
24-pin connector.
7. Power-on and Loading BIOS Setup
After you finish the setting of jumpers and connect correct cables. Power
on and enter the BIOS Setup, press <Del> during POST (Power On Self
Del
Test).
Choose "Load Setup Defaults" for recommended optimal
performance.
Warning: Please avoid of using "Load Turbo Defaults", unless you are sure your
system components (CPU, RAM, HDD, etc.) are good enough for turbo setting.
8. AOpen Bonus Pack CD and EzInstall
You can use the autorun menu of Bonus CD disc. Choose the utility and driver
from the icons at left side, and then click on the "GO" button to complete
installation automatically.
Install driver
Install utility
Browse
Read me
Exit CD
Click to install
online manual
Advertisement
Table of Contents
