AOpen MX3ZA User Manual page 90

Table of Contents

Advertisement

Integrated Peripherals
Integrated Peripherals
Integrated Peripherals
Integrated Peripherals
IDE Primary Master
UDMA
Auto
Disabled
Integrated Peripherals
Integrated Peripherals
On-Chip Primary
PCI IDE
Enabled
Disabled
Integrated Peripherals
USB Keyboard
Support
Enabled
Disabled
Integrated Peripherals
Init Display First
PCI
AGP
IDE Primary Master UDMA
IDE Primary Slave UDMA
IDE Secondary Master UDMA
IDE Secondary Slave UDMA
This item allows you to set the Ultra DMA/33 mode
supported by the hard disk drive connected to your
primary IDE connector.
On-Chip Primary PCI IDE
On-Chip Secondary PCI IDE
This parameter lets you enable or disable the IDE
device connected to the primary IDE connector.
USB Keyboard Support
This item lets you enable or disable the USB
keyboard driver within the onboard BIOS. The
keyboard driver simulates legacy keyboard command
and let you use USB keyboard during POST or after
boot if you don't have USB driver in the operating
system.
Caution: You can not use both USB driver
and USB legacy keyboard at the same time.
Disable "USB Keyboard Support" if you have
USB driver in the operating system.
Init Display First
If you installed a PCI VGA card and an AGP card at
the same time, this item lets you decide which one is
the initial display card.
AWARD BIOS
4-31

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mx3l

Table of Contents