Ice Station Assembly Installation; Top Freezer Models; Bottom Freezer Models - Electrolux END 5298 Care And Use Instructions Manual

Ice Station Assembly Installation

To fit the Ice station assembly to a top freezer model;
Fit the Ice Station carrier to the wire shelf by alligning the
outside of the carrier to the wires as shown in diagram 1.
Then push down in the middle of the carrier until it clips into
place as shown in diagram 2
Finally, slide the ice cube trays or storage bin into position
as shown in diagram 2
To remove, take out the ice cube trays and storage bin and
simply lift the carrier off the wire shelf.
3 - Installation
To front of
shelf
Diagram 1
Diagram 2
To fit the Ice station assembly to a bottom freezer model;
Fit the Ice Station carrier to the wire shelf by alligning the
outside of the carrier to the wires as shown in diagram 1.
To rear of
shelf
Diagram 2
Diagram 3
Then push up in the middle of the carrier until it clips into
place
Finally, slide the ice cube trays or storage bin into position
as shown in diagram 3
To remove, take out the ice cube trays and storage bin and
simply pull the carrier off the wire shelf.
Page 7
Diagram 1
Make sure the four clips are
engaged onto the central wire (as
shown in diagram 2)
(Some models only)