Changing The Light Bulb; Food Compartment; Freezer Compartment; Care & Maintenance - Electrolux END 5298 Care And Use Instructions Manual

Changing the Light Bulb

Food Compartment

Step 1.
Switch off the power at the power point and remove the
refrigerator's electric cord from the power point.
Step 2.
Carefully unclip the light cover. You do this by pulling the light
cover tab at the rear towards the front of the cabinet.
Step 3.
Unscrew the light bulb and replace it with a bulb that is the
same as the original (25 watts)
Step 4.
Replace the light cover by hooking the light cover lugs into
the front of the housing and pressing the rear of the cover up
until it clips in.
Step 5.
Wait 5 minutes to ensure pressures in the refrigeration system
are equalized. Then turn the refrigerator on at the power
point.
5 - Care & Maintenance
Page 15
Freezer Compartment (where fitted)
Step 1.
Switch off the power at the power point and remove the
refrigerator's power cord from the power point.
Step 2.
Carefully unclip the light cover. You do this by pulling the light
cover tab at the rear towards the front of the cabinet. (See
Diagram below)
Step 3.
Unscrew the light bulb and replace it with a bulb that is the
same as the original.
Step 4.
Replace the light cover by hooking the light cover lugs into
the front of the housing and pressing the rear of the cover up
until it clips in.
Step 5.
Wait 5 minutes to ensure pressures in the refrigeration system
are equalized. Then turn the refrigerator on at the power
point.