Table of Contents
Advertisement
Wi-Fi network Setup for AirPlay / DLNA (continued)
Connection via wireless router with WPS
■
�
Press the WPS button on the wireless router.
WPS
�
Press the ON/STAND-BY button.
3�
Press the NETWORK button.
�
Press the iPod MENU button on the remote control.
5�
Press the / button to select 'Wi-Fi Setup'.
Press the ENTER button.
6�
Press the / button to select 'WPS'. Press the ENTER
button. Wait until '
and the display shows "Successfully Connected to
[network name]".
7�
On the iPod touch/iPhone/iPad, select 'Settings' --> 'Wi-Fi'.
On the PC/Mac, enter the list of available wireless networks.
For other DLNA compatible devices, turn on the Wi-Fi. For
more details, refer to your devices' manual.
8�
Select your router from the list of available networks.
Enter your network password if required.
9�
Continue with step 8 to 9 in 'Direct wireless connection'
on page 5.
Note:
WPS process (network search) takes about 2 minutes. If
fail to connect, the display will show 'Cannot connect to
Network. Please try again.'. Repeat step 4 to retry or do
"Connection via SSID".
Connection via SSID (wireless router
■
without WPS)
�
Press the ON/STAND-BY button.
�
Press the NETWORK button on the remote control.
3�
Press the iPod MENU button on the remote control.
�
Press the / button to select 'Wi-Fi Setup'.
Press the ENTER button.
5�
Press the / button to select 'SSID Set'. Press the
ENTER button. Wait until the display shows "SSID
Ready" which takes about 40 seconds.
6�
On the iPod touch/iPhone/iPad, select 'Settings' --> 'Wi-Fi'.
On the PC/Mac, enter the list of available wireless networks.
For other DLNA compatible devices, turn on the Wi-Fi.
For more details, refer to your devices' manual.
7�
Select Sharp_DK-KP95 from the list of available
networks.
8�
Open web browser as Safari or Explorer on iPod touch
/ iPhone / iPad or PC/Mac. Type 9.68.. at the
address bar.
The DK-KP95 configuration page is displayed.
SHARP DK-KP95
Network Configuration
' on the display stops blinking
192.168.1.1
9�
Select Network Configuration tab.
0�
Select your router SSID from the pull-down list of
Service Set ID (SSID).
�
Enter your network password if required (for some
routers, you may also need to tick DHCP under
Advance Setting).
�
Change the name of SHARP_DK-KP95_xxxxxx in
AirPlay Device Name if you like and click Apply (*1).
3�
Click Apply (*2) at the bottom of the page to apply
your settings.
*1
*2
�
Click OK to confirm your settings.
5�
On the iPod touch/iPhone/iPad, select 'Settings' --> 'Wi-Fi'.
On the PC/Mac, enter the list of available wireless networks.
6�
Select your router from the list of available networks.
7�
Continue with step 8 to 9 in 'Direct wireless connection'
of page 5.
6
Advertisement
Table of Contents
