Wiring Identification - JBL MR-18.5 Operation Manual

Wiring Identification

(ANT JACK)
GRAY BLACK
(AUX)
(REAR
LINE OUT)
12P CONNECTOR
BLUE
(AUTO ANT)
FUSE
YELLOW
( BACK-UP B+ )
10A
BLACK
( GROUND )
RED
( IGNITION B+ )
WHITE
( FRONT LEFT )
WHITE/BLACK
GREEN
( REAR LEFT )
GREEN/BLACK
NOTE: When wiring, both the yellow and red lead must be hooked up. The yellow lead
goes to the battery while the preferred method for the red wire is ACC/ignition
power lead.
4
GRAY
(FRONT RIGHT )
GRAY/BLACK
VIOLET
( REAR RIGHT )
VIOLET/BLACK
Auxiliary Input Mode
A. Press the Mode button until "AUX" appears on the LCD screen.
B. The use of auxiliary mode allows you to play the portable music device through
the headphone jack. An auxiliary adaptor will need to be purchased separately
(Prospec offers part, SEAMINI2).
RCA output
Description: The use of RCA outputs allow an amplifier or subwoofer to be connected.
Remote Option
A. RF remote option.
This CD unit was built with an internal RF receiver. Simply purchase the associated
transmitter (Prospec part, MILRF9) to complete the option. The RF remote will allow
wireless remote operability up to 30 feet away.
MILRF9 Function and Name
1. POWER ON/OFF button
2. MODE button
(Radio --> CD --> AUX-IN)
3. CD Play/Pause, Radio BAND button
4. MUTE button
5. VOLUME UP button
6. VOLUME DOWN button
7. TUNE / TRACK DOWN button
8. TUNE / TRACK UP button
9. SEL (select) button
Short push: VOL --> BAS --> TRE -->
BAL --> FAD.
Press and hold: BEEP 2ND --> I-VOL
--> AREA --> DSP.
How to exchange the battery
Open the cover of the back of remote marked Battery.
Place battery as indicated on the back of the remote noting polarity.
* Replacement Battery : Cr2025
1
3
POWER BAND/PAUSE
2 4
MODE MUTE
5
9
8
7
SEL
TUNE TRACK
6
VOL
13