Page 1
This product is sold and serviced exclusively by Prospec Electronics Inc. and must be returned to Prospec for in and out of warranty repairs. It can not be serviced under warranty by other JBL service centers. All products sold and serviced exclusively by Prospec Electronics Inc.
Page 2
Please find enclosed nylon wire tie-downs (wire clamps) for added support. PLEASE NOTE: In order to receive Sirius Satellite Radio broadcast, you must install JBL Sir2.5 as well as a satellite antenna (both sold separately). What is SIRIUS Satellite Radio? SIRIUS, headquartered in New York, offers over 120 channels of digital quality radio t ransmitted across the continental US from three high-tech satellites.
Wiring identification Trouble shooting guide ( SIRIUS control ) INTERFERENCE ON RADIO Poor atmospheric conditions - Try again later in the day ( AUX-IN ) Antenna / lead broken or damaged (CD changer socket) DISTORTED AUDIO (Remote Control) (ANT. socket) (Front Panel Control) Check loudspeaker wiring CONNECTOR...
Page 4
Operating the CD changer (CD changer purchased separately) Installing and Removing the Faceplate 1. To remove the face plate: a. When the unit needs service, press this SVC button to remove front panel. b. The faceplate cable will also need to be unplugged from the black command module.
Important notes Station Tuning Prior to the final installation, carry out a sound check. If high distortion or intermittent sound is experienced, it is possible that the wiring from the CD receiver to the boat's electrical system is poor or that the battery needs recharging. If the battery and its charging circuit are OK, then rewire the yellow fused wire of the CD player directly to the positive terminal (+) of the boat battery.
Remote Control (Option) Identification of controls and functions A. Function and Name 1. Power on/off button 2 2 2 2. MODE button < Radio -> CD -> CDC -> SIRIUS -> AUX-IN > MODE 3. CD Play/Pause / preset 1 button SEEK 4.
Page 7
Controls (In Detail) Controls (In Detail) Continued a. Beep 2nd On the beep 2nd, you can control the Beep on or Beep 2nd by turning the spindle knob. - Beep on : You can hear "beep" sound when you press all buttons. - Beep 2nd :You can hear "beep"...