8
Reinstall the existing hard drive into the computer in front of the additional drive
(see page 65).
9
Connect a power cable to the drive.
10
Connect the data cable to the drive and to the system board (see page 51).
11
Replace the computer cover (see page 77).
NOTICE:
the computer.
12
Connect your computer and devices to electrical outlets, and turn them on.
13
See the documentation that came with the drive for instructions on installing any software
required for drive operation.
68
Removing and Installing Parts
To connect a network cable, first plug the cable into the network wall jack and then plug it into
additional hard drive
drive slots (2)
bracket tabs (2)
front computer frame
bracket-securing
screw
drive bracket
bracket-securing
screw