Supplied Accessories And Attachments - Icom IC-M31 Instruction Manual

2

SUPPLIED ACCESSORIES AND ATTACHMENTS

ï Battery pack
To remove the battery pack:
Turn the screw counterclockwise, then pull the battery pack
in the direction of the arrow as shown below.
To attach the battery pack:
Insert the battery pack in the IC-M31 completely, then turn the
screw clockwise.
NEVER remove or insert the battery pack when the trans-
ceiver is wet or soiled. This may result water or dust get-
ting into the transceiver/battery pack and may result in the
transceiver being damaged.
Screw position
when removing battery
OPEN
Screw position
when attaching battery
OPEN
3
NOTE: When removing or attaching the battery pack, use
a coin or flat-blade screwdriver to loosen or tighten the bot-
tom screw.
CAUTION!:
When attaching or removing a battery pack, make sure the
rubber seal is set in the groove of the battery pack cor-
rectly. If the seal is not neatly in the groove it may be dam-
aged when attaching the battery pack.
If the seal is damaged, waterproofing is not guaranteed.
NOTE:
When attaching a battery pack, make sure dust or else does
not adhere to the rubber seal. If dust or else is on the seal
when attaching a battery pack, the water resistant may be
reduced.
Make sure both the rubber seal (purple) is set to the groove
correctly and dust or else does not adhere to it.
Correct position
Rubber seal
Groove
Battery pack
Incorrect position
Battery pack