Table of Contents
Advertisement
HOW TO OPERATE
1. TEMPERATURE CONTROL
Temperature is controlled by thermostat automatically.
The Temperature Control inside the refrigerator controls the degree of cooling for each compartment.
Freezer Temperature Control
TEMP. CONTROL
MIN
MED
MAX WINTER
The control has four settings form MIN to
WINTER. The WINTER mode is available only
if atmosphere temperature is below 10°C.
Starting your new refrigerator
1. Clean the refrigerator thoroughly. Wipe the outside with a dry cloth, and the inside with a damp cloth.
2. Set the temperature control knob at normal position.
3. Connect the power supply cord.
To control temperature
Many factors may influence the internal temperature of the refrigerator and freezer compartments.
The temperature and humidity of the surrounding environment.
The opening frequency of the doors and the amount of warm food placed in the refrigerator.
The combination of food and containers stored in the refrigerator.
For these reasons, you may want to adjust the control to suit the season and your needs.
Turn the temperature control in the refrigerator and freezer compartments toward
WINTER for colder temperature and toward MIN for warmer temperature.
Allow approximately 12 hours or overnight for the temperature to stabilize.
Then check to see if further adjustments are necessary.
To turn off the refrigerator
Disconnect the power supply cord. Remove icing case and food. Leave
doors ajar for ventilation and dehumidification of both compartments.
Refrigerator Temperature Control
WINTER
MAX
MED
MIN
TEMP. CONTROL
The control has the four settings from MIN to
WINTER. The WINTER mode is available only if
atmosphere temperature is below 10°C.
9
2. DEFROSTING THE REFRIGERATOR
You will never have to defrost your refrigerator as it is designed to
defrost itself completely and automatically.
CAUTION
To avoid the risk of electric shock or death, unplug the power cord
before replacing a burned out light bulb or cleaning the inner
parts.
3. RADIANT HEAT
With the Refrigerating System in operation, it is likely that the cabinet will feel
warm at the front edges and sides. This does not indicate trouble.
It is due to the hot-line used in this type of Refrigerating System which consists of
piping hot gas from the (motor-driven) compressor along the front edges, the
sides of the cabinet and the center partition to prevent dewing. This has nothing
to do with the storage temperature inside.
During spells of hot, humid weather and in rainy season,
moisture may develop on the cabinet, just as water
condenses around a cold glass of water. It is not an
abnormal condition; wipe off the moisture with a dry cloth.
This can also happen when the refrigerator is not installed
in an appropriate place.
10
Advertisement
Table of Contents
