Fitting The Trimmer Guard And Trimmer Head Trimmy Sii; Fitting Other Guards And Cutting Attachments - Husqvarna 232R Operator's Manual

Fitting the trimmer guard and
trimmer head Trimmy SII (235R,
235FR)
• Fit the correct trimmer guard (A) for use with the
trimmer head. CAUTION! Ensure that the guard
extension is fitted.
Hang the trimmer guard/combination guard (A) on the
two hooks on the plate holder (M). Bend the guard
around the shaft and tighten it with the bolt (L) on the
opposite side of the shaft. Use the locking pin (C).
Place the locking pin in the groove on the screw head
and tighten. See diagram.
L
M
A
• Fit the drive disc (B) on the output shaft.
• Turn the blade shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Screw on the trimmer head (H) in the opposite
direction to the direction of rotation.
H
• Tighten the trimmer head to a torque of 35-50 Nm
(3.5-5 kpm).
• To dismantle, follow the instructions in the reverse
order.
18 – English
H
C B
M L
ASSEMBLY
Fitting other guards and cutting
attachments (232R)
A
• Fit the trimmer guard/combination guard (A) intended
for use with the trimmer head/plastic blades. Secure
the trimmer guard/combination guard using four
screws (L) and the support plate (M) as shown.
• Fit the drive disc (B) on the output shaft.
• Turn the blade shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Screw on the trimmer head/plastic blades (H) in the
opposite direction to the direction of rotation.
Fitting other guards and cutting
attachments (235R, 235FR)
• Fit the trimmer guard/combination guard (A) intended
for use with the trimmer head/plastic blades.
CAUTION! Ensure that the guard extension is fitted.
Hang the trimmer guard/combination guard (A) on the
two hooks on the plate holder (M). Bend the guard
around the shaft and tighten it with the bolt (L) on the
opposite side of the shaft. Use the locking pin (C).
A
L
B
C
M
H
H