Fitting The Trimmer Guard And Trimmer Head; Connecting Throttle Cable And Stop Switch Wires - Husqvarna 132R, 133R, 142R, 143R Operator's Manual

• Fit the nut (G). The nut must be tightened to a torque of
35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool
kit. Hold the shaft of the spanner as close to the blade
guard as possible. To tighten the nut, turn the spanner in
the opposite direction to the direction of rotation (Caution!
left-hand thread).
132R
133R
G
E
F
D
B
C
Fitting the trimmer guard and
trimmer head
• Fit the correct trimmer guard (A) for use with the trimmer
head.
• 132R: Secure the trimmer guard using the 4 screws (L)
and the support plate (M) as shown.
A
L
B
C
M
133R: Hook the trimmer guard/combination guard onto
the fitting on the shaft and secure with the bolt (L).
142R: Fit the guard (A) to the gear housing using the
support plate (M) and two screws (L). CAUTION! Ensure
that the guard extension is fitted.
B
L
C
M
A
14 –
English
ASSEMBLY
142R/143R
G
E
F
D
B
C
A
143R: Fit the correct trimmer guard (A) for use with the
trimmer head. CAUTION! Ensure that the guard extension
is fitted.
Hook the trimmer guard/combination guard onto the fitting
on the shaft and secure with the bolt (L).
G
M
E
F
D A
• Fit the drive disc (B) on the output shaft.
B
C
• Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Screw on the trimmer head/plastic blades (H) in the
opposite direction to the direction of rotation.
H
• To dismantle, follow the instructions in the reverse order.
Connecting throttle cable and stop
switch wires
1 Insert the throttle cable through the cable adjuster sleeve
on the carburettor bracket. Make sure the end of the
throttle cable housing is seated positively in the sleeve.
2 Position the slotted fitting on the carburettor so the
recessed hole (A) is away from the cable adjuster sleeve.
3 Rotade the carburettor throttle cam and slip the throttle
cable through the slot in the slotted fitting, making sure the
cable lug drops into the recessed hole.
4 Press the throttle trigger a few times to check that it works.
5 Connect the stop switch wires to the wires from the engine
(it is not important which wire is connected to which).
H
L
C B
M L
H
A