Trouble-Shooting; Helpful Hints - One for All 6 User Manual & Code Book

Problem:
Red light does not
blink when you press
a key?
The ONE FOR ALL
does not respond after
pressing a key?
The ONE FOR ALL
does not operate your
device(s)?
Your brand is not
listed in the ONE FOR
ALL code section?
When following the set- Did you use the Code Lock fea-
up instructions, the red
light on the ONE FOR
ALL only blinks once in- Follow the instructions on page
stead of twice after you
enter a three-digit code?
The ONE FOR ALL
is not preforming
commands properly?
Press a key but get
the wrong result?
You cannot control the
volume feature of your
Satellite, Cable Con-
verter or TV/Video
combination?
Problems changing
channels?
Video not recording?
Scan does not work
on your device?

Helpful Hints

Solution:
Replace batteries with 4 fresh,
new AAA alkaline batteries.
Make sure you are using new
batteries and are aiming the
ONE FOR ALL at your device.
A) Try all the codes listed for
your brand. B) Try the search
method on page 11.
Try the search method on page 11.
ture? You must first unlock the
code before entering a new code.
23 to do this.
You may be using the wrong
code. Start the search method
over again to locate the proper
code.
Hold MAGIC until the red
light blinks twice, then press
992 and the device key twice.
You will need to set up your
device again. Try the codes for
brand or the search method
on page 11.
Hold MAGIC until red light
blinks twice. Then press 993
and VOL+. To set the
volume control back to TV
(Punch Through), hold MAGIC
until the red light blinks twice
then press 993 TV.
Enter the programme number
exactly as you would on your
original remote.
As a safety feature on your ONE
FOR ALL, you must press the
Record key twice .
Make sure your original remote
had a programme +/- key.
24