Getting Your Messages - Uniden 1035 Series Owner's Manual

 If you don't want to record a greeting, the system uses a pre-
recorded greeting: Hello, no one is available to take your call. Please
 After you record a greeting, you can switch between the pre-
leave a message after the tone.
recorded greeting to your personal greeting at any time.
1. Access the answering system from any handset. Wait until the
Record a Personal Greeting
system finishes its announcements, or press
2. Press
3. Wait for the system to say "Record greeting," then begin speaking.
(RecNewGreeting).
8
4. When you're finished, press
back your new greeting.
5. To keep this greeting, press
1. Access the answering system from any handset. Wait until the
Switch Between the Two Greetings
system finishes its announcements or press
2. Press (SelectGreeting) to play back the current greeting.
3. Press again to switch greetings.
6
6
Switch to your personal greeting following the steps above, then press
Delete Your Greeting
(Delete) while the system is playing back your greeting.
4

Getting Your Messages

To...
play new
messages
replay an earlier
message
From the base
Press
play/sTOp.
The system announces the number of new and old
messages, then plays each new message (followed by
the time and day) in the order it was received.
Within 2 seconds after a message starts playing,
press
REpEaT.
to stop recording. The system plays
8
. To re-record it, go back to step 2.
End
to skip them.
5 (sTOp)
to skip them.
Stop
5 ( )
From a handset
(remote operation)
Press
mEnu/sElECT
times.
select 1:Repeat.
two
17