Denon AVR-3311 Owner's Manual page 113

GAudioH
Symptom
Audio is not output. • Check the connections for all devices.
• Check the speaker connections.
• Check whether the audio device power is turned on.
• Adjust the master volume.
• Cancel the mute mode.
• Select a suitable input source.
• Select a suitable input mode.
• Disconnect the headphones. No sound is output from the speakers
or the PRE OUT connectors when headphones are connected.
No sound is • Check if the surround speakers are connected to the SURROUND
produced from terminals.
surround speaker.
No sound is • Set "Amp Assign" on the menu to "Normal".
produced from • Set "Speaker Config." – "S.Back" on the menu to something
surround back other than "None".
speaker. • Set "Surround Parameter" – "S.Back" on the menu to something
other than "OFF".
• Set the surround mode to something other than "STEREO".
No sound is • Set "Surround Parameter" – "F.Height" on the menu to "ON".
produced from front • Set "Amp Assign" on the menu to "Normal".
height speaker. • Set "Speaker Config." – "Surround" on the menu to something
other than "None".
No sound is • Check the subwoofer connections.
produced from • Turn on the subwoofer's power.
subwoofer. • Set "Speaker Config." – "Subwoofer" on the menu to "Yes".
• If "Front" and "Center" for "Speaker Config." are set to "Large",
and "Subwoofer Mode" is set to "LFE", no sound may be output
from the subwoofers, depending on the input signal or selected
surround mode.
DTS sound is not • Set "Decode Mode" on the menu to "Auto" or "DTS".
output.
Dolby TrueHD, DTS- • Make HDMI connections.
HD, Dolby Digital
Plus audio is not
output.
Cause/Solution
5, 14 – 23
5, 45 – 48
5, 45 – 48
GHDMIH
Page Symptom
No audio is • Check the connection of the HDMI connectors.
output with HDMI • When outputting HDMI audio from the speakers, set "HDMI
– connection. Audio Out" on the menu to "AMP".
24, 58 • When outputting HDMI audio from a TV, set "HDMI Audio Out"
25, 58 on the menu to "TV".
24, 58
No video is • Check the connection of the HDMI connectors.
67
output with HDMI • Set the input source to match the connected HDMI connector.
95
connection. • Check whether the TV is compatible with copyright protection
(HDCP). If connected to a device not compatible with HDCP, video
– will not be output correctly.
When the following • Set "HDMI Control" on the menu to "OFF". To operate power
operations are only for each device, set "Power Off Control" to "OFF".
75 performed on
75 devices compatible
with HDMI control,
70 the same operations
occur on this unit.
42 • Power ON/OFF
• Switching audio
69
output devices
75
• Adjust volume
75
• Switch input source
GRadioH
6
Symptom
75
Reception fails, or • Change the antenna orientation or position.
75
there is a lot of noise • Separate the AM loop antenna from the unit.
or distortion. • Use an FM outdoor antenna.
• Separate the antenna from other connection cables.
67
GControl dock for iPodH
Symptom
14
iPod cannot be • Check the iPod connections.
played. • Plug the control dock for iPod's AC adapter into a power outlet.
• Switch the input source to "DOCK".
Cause/Solution
Cause/Solution
Cause/Solution
ENGLISH
Page
14
77
77
14
14, 24
14
50, 78
Page
20
20
20
20
Page
19
–
24
109