Generac Power Systems MITSUBISHI GAS ENGINE 0G2832 Service Manual page 7

Maintenance Tasks
14. Visually inspect the
unit looking for leaks,
wear or damage, loose
connections or compo-
nents, and corrosion.
Correct as necessary.
15. Test the engine and
transfer switch safety
devices. Correct and/or
adjust as necessary.
16. Initiate an automatic
start and transfer of the
unit to site load and
exercise it for at least 1
hour looking for leaks,
loose connections
or components, and
abnormal operating
conditions. Correct as
necessary.
17. Start and exercise the
unit at full rated load
(use a load bank if the
site load is not enough)
for at least 2 hours
looking for leaks, loose
connections or com-
ponents, and abnormal
operating conditions.
Correct as necessary.
18. Change the engine oil.
19. Replace the engine oil
filter(s).
20. Replace the engine air
filter(s).
21. Replace the engine
fuel filter(s) on diesel
engine driven units
and re-prime the fuel
system.
22. Check the engine
spark plugs on gas
engine driven units.
Clean and re-gap orre-
place as necessary.
23. Perform a 5 minute no-
load operational run of
the unit looking for any
post service problems.
24. Return the unit to
standby setup for oper-
ation when required.
Level 1
Task
Recommended
Comp.
to be done
(Date-
monthly/ 10 hrs. Break-in /30 hrs.
Initials)
•
•
2.4 Liter Gas engine Service recommendations
Level 2
Task
Required to be
Comp.
done 3 months/
(Date-
Annually/50 hrs.
Initials)
•
•
•
•
•
•
•
•

Level 3
Task
Required to Required to be
Comp.
be done Semi- done Annually/
(Date-
Initials)
•
•
•
Level 4
Task
Comp.
(Date-
100 hrs.
Initials)
•
•
•
•
•
•
•
•
•
•