PRODUCT SPECIFICaTIONS
display:
Picture resolution: Photo: 640 x 480
Focus range:
Flash range:
Memory:
16 MB built-in memory (approximately 12 MB free memory for photo/movie storage).
Photos: Can store around 200 photos (photo size = 640 x 480 resolution in JPEG format).
Movies: Records up to 5 minutes of movies (movie size = 160 x 120 resolution in Motion JPEG format).
Kidizoom Camera™ supports up to a 2 GB Secure Digital (SD) memory card (not included) for
memory expansion.
supported File Formats:
Photo: JPEG (up to 2 M pixels at 1632 x 1224 resolution)
Movie: Kidizoom Camera™ Motion JPEG
supported Hardware:
A/V cable for TV connection (included)
USB cable for PC connection (included)
SD memory cards (not included) up to 2 GB
GETTING STaRTED
BaTTery InsTaLLaTIon
note: Adult assistance is required for battery installation. Use a screwdriver to install batteries.
•
Make sure the camera is turned
•
Locate the battery covers on the bottom of the camera. Loosen the screws using the
screwdriver and remove the battery covers.
•
Install 4 new C (LR6/AA) batteries (2 on each side) as illustrated below.
(The use of new, alkaline batteries is
recommended for maximum performance.)
•
Replace the battery covers and tighten the
screws. Do not over-tighten screws.
note: If Kidizoom Camera™ is not working properly
after the batteries have been replaced, press the Reset
Button and then restart the camera. Pressing the Reset
Button will erase all data in the Kidizoom Camera™
internal memory, but it will not erase any data saved
on an SD memory card (not included) if one is being used.
recommendation:
When the batteries in Kidizoom Camera™ run out
few minutes, the data in the internal memory may be lost. We recommend using an SD memory card
(not included) and setting it as the default for saving photos or movies taken by Kidizoom Camera™.
If an SD memory card (not included) is not used, remember to copy your photos and movies from the
camera's internal memory to a PC before the
batteries run out or are taken out.
BaTTery noTICe
•
Using new alkaline batteries for maximum performance is recommended.
•
Install batteries correctly observing the polarity (+, -) signs to avoid leakage.
•
Do not mix old and new batteries.
•
Do not mix batteries of different types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
•
Remove the batteries from the equipment when the unit will not be used for an extended period of
time. Please note: To prevent data loss, copy all photos and movies from Kidizoom Camera™ to a
PC before removing batteries.
•
Always remove exhausted batteries from the equipment.
•
Do not dispose of batteries in fire.
•
Do not attempt to recharge ordinary batteries.
•
The supply terminals are not to be short-circuited.
•
Only batteries of the same and equivalent type as recommended are to be used.
We do not recommend the use of rechargeable batteries.
sd MeMory Card InserTIon
Kidizoom Camera™ supports up to a 2 GB Secure Digital (SD) memory card
(not included) for memory expansion.
•
Make sure the camera is turned
•
Open the battery cover on the right side
(as you are facing the camera's LCD screen).
•
Locate the SD card slot inside.
•
Insert the SD card (not included) as illustrated below.
•
Replace the battery cover and tighten the screw.
Do not over-tighten the screw.
3
1.8" TFT colour LCD
Movie: 160 x 120
45 cm - ∞
1 – 2 metres
oFF.
oFF.
or are taken out for more than a
SD card
Need help?
Do you have a question about the Kidizoom camera and is the answer not in the manual?
Questions and answers