Macpower & Tytech PD-SATA User Manual page 19

Make sure all
current operations
are done before
rebooting the
device.
Resetting the
device will remove
all folders from the
sharing list, erase
the FTP accounts
and reset all other
settings!
USER MANUAL USER MANUAL
PD-SATA USB/LAN PD-SATA USB/LAN
• System Reboot: This can be used to restart the network
drive after a firmware upgrade.
1. Click on Reboot.
2. Confirm the pop-up message to restart the device.
3. Wait for about one minute before refreshing the page.
• Factory Defaults: If you experience problems and after a
firmware upgrade, it is recommended to reset all settings.
1. Click on Reset.
2. Confirm the pop-up message to reset all settings.
3. Click on Reboot to restart the device.
Page 17 / Chapter 4 - LAN Disk Setup Page 17 / Chapter 4 - LAN Disk Setup