Remarks for Mac users and Apple Macintosh OS The DC-SATA Sleek and elegant, the new DC-SATA is everything you would expect from Macpower. With an array of interfaces, this latest addition to the Daisy Cutter family is the perfect enclosure for Features mentioned 2.5"...
Status ON, power ON Status ON, data access * Status OFF * Red LED flickers during data access. The DC-SATA 400+, 800+ and S2 are using a single blue LED. Blue LED Status ON, power ON Status ON, data access...
DC-SATA USB 2.0 1. Remove the two screws from the rear panel and pull the panel with the bridge board gently out of the enclosure.
Page 6
DC-SATA User Guide 3. Mount the bridge board to the hard drive with the two screws from the bottom as seen in following illustration. 4. Slide the bridge board and hard drive back into the enclosure. Be careful not to...
DC-SATA User Guide DC-SATA 400+/800+/S2 1. Remove the two screws from the rear panel. 2. Remove the rear panel and pull the bridge board gently out of the enclosure. 3. Install the hard drive. Page 5 / Chapter 2 - HDD Assembly...
Page 8
DC-SATA User Guide 4. Mount the hard drive with the four screws from the bottom as seen in following illustration. 5. Slide the bridge board and hard drive back into the enclosure. Be careful not to damage any components during the assembly.
DC-SATA User Guide Chapter 3 - System Set Up Connection to your Computer Here are a few tips on how to use your storage enclosure: Only one interface • Check the power cord and cables for visible damage before can be used at any turning it on.
DC-SATA User Guide Installation on a PC If the drive has been pre-installed and setup already, you do not need to prepare anything else and can use it straight away. If you have installed the drive yourself and this is a brand new...
DC-SATA User Guide Installation on a Macintosh If the drive has been pre-installed and setup already, you do not need to prepare anything else and can use the unit straight If the system away. If you have installed the drive yourself and this is a brand doesn’t recognise...
DC-SATA User Guide Partitioning & Formatting Be aware that this will destroy any existing data on the drive, so You can choose to make sure you have a backup! This step is usually only create several required the first time you install a factory new hard drive, if you partitions but be change the format or want to erase all data on your drive.
DC-SATA User Guide PC running Windows 2000, XP or Vista For Windows 2000 and above, use the Disk Management Program to setup your drive. • Right click on “My Computer” and choose “Manage” If the drive does not • Select “Disk Management”...
DC-SATA User Guide Mac OS For Mac OS X, use the Disk Utility to format and create partitions on your external disk. • Select “Disk Utility” in the utilities folder If the drive does not • Choose your external drive and format it according to your...