Troubleshooting - Roland M-300 Owner's Manual Addendum

Troubleshooting

* For problems related to communication, refer also to the owner's manual of your wireless LAN access point.
* For details on operating your wireless LAN access point, refer to its owner's manual.
Cannot connect to a wireless LAN access point
The M-300 displays "Could not make the wireless connection".
• Make sure that your wireless LAN access point supports WPS.
• If your wireless LAN access point does not support WPS, you can connect using the procedure described in "Connecting to a Wireless LAN
Access Point That You Select" (p. 8).
• The 802.11a/b wireless standard is not supported. Please use the 802.11g/n (2.4 GHz) wireless standard.
• The WEP authentication method is not supported. Please use the WPA or WPA2 authentication method.
• Make sure that DHCP is enabled for your wireless LAN access point.
• If you cannot get connected to the previously-connected wireless LAN access point when you turn on the unit, check and make sure the setting
described in "Connecting in Ad-Hoc mode" (p. 9) is OFF.
• The connection might not occur successfully due to the state of the radio signal. If so, use the procedure described in "Connecting to a Wireless
LAN Access Point That You Select" (p. 8), and select your wireless LAN access point and reconnect.
• There is a limit to the amount of connection data that can be remembered. Making a new connection may cause older connection data to be
deleted.
• All connection data will be deleted if you execute a factory reset. If the connection data has been deleted, please re-connect to the wireless LAN
access point.
• The project file that is saved to the USB memory does not contain connection data. Please re-connect to the wireless LAN access point.
The M-300 displays "This Access Point is not supported" and cannot connect to the access point.
This Access Point is not supported. Please use the WPA or WPA2 authentication method.
Communication is unstable
Communication may be unstable depending on the of the radio signal status. If communication is unstable, the response may be
sluggish. The following actions may improve the situation.
• Move the wireless LAN access point and the M-300 unit closer to each other.
• Change the channel setting of the wireless LAN access point.
The M-300 is not found in the application (M-300 Remote)
• Is the M-300 powered up?
• Is the wireless USB adapter (WNA1100-RL) properly connected to the M-300?
• Is "Enable Wireless LAN" in REMOTE popup (WIRELESS LAN tab) checked?
• Is the M-300 connected to the wireless LAN?
• Are the M-300 and the iPad connected to the same network (same wireless LAN access point)?
• Is the wireless LAN access point set to allow communication between wireless LAN devices?
* For details on settings, refer to the owner's manual of your wireless LAN access point.
Cannot connect the iPad to the internet
• Is the wireless LAN access point connected to the Internet?
• Could you be connected in Ad-Hoc mode?
The iPad or other wireless device connected in Ad-Hoc mode will be unable to communicate with the Internet or with another wireless device.
However, an iPad or other wireless device that has cellular capability will be able to connect to the Internet via the cellular connection.
About the Wireless LAN Function
11