ASL INTERCOM TS 99 User Manual

ASL INTERCOM TS 99 User Manual

Theater series cue light master station, cue light receiver, cue light preset control

Advertisement

Quick Links

CUE LIGHT MASTER STATION
CUE LIGHT PRESET CONTROL
1
2
3
4
CONTENTS
THEATER SERIES
USER MANUAL
FOR THE
TS 120 / TS 10 / TS 99
CUE LIGHT RECEIVER
7
5
6
8
1.0
GENERAL DESCRIPTION ..........................................3
2.0
UNPACKING ...............................................................3
3.0
INSTALLATION...........................................................3
4.0
FRONT PANEL CONTROLS.......................................4
5.0
REAR PANEL CONNECTORS....................................5
6.0
INTERNAL CONTROLS ..............................................5
7.0
CABLING.....................................................................5
8.0
PARTY LINE, TECHNICAL CONCEPT .......................6
9.0
GUARANTEE ..............................................................7
10.0
TECHNICAL SPECIFICATIONS..................................7
R
9
10
11
12
clear
All selected
channels

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TS 99 and is the answer not in the manual?

Questions and answers

Summary of Contents for ASL INTERCOM TS 99

  • Page 1: Table Of Contents

    THEATER SERIES USER MANUAL FOR THE TS 120 / TS 10 / TS 99 CUE LIGHT MASTER STATION CUE LIGHT RECEIVER CUE LIGHT PRESET CONTROL clear All selected channels CONTENTS GENERAL DESCRIPTION ..........3 UNPACKING ...............3 INSTALLATION............3 FRONT PANEL CONTROLS........4 REAR PANEL CONNECTORS........5 INTERNAL CONTROLS ..........5...
  • Page 2 User Manual TS 120 / Issue 1 2000 ASL Intercom, Utrecht, Holland.
  • Page 3: General Description

    The power supply is located on the rear of the unit, and after a period of time it will feel hot to the touch. This is quite normal, and should be no cause for alarm. User Manual TS 120 / Issue 1 2000 ASL Intercom, Utrecht, Holland.
  • Page 4: Front Panel Controls

    When the GO signal is activated by pushing the GO button (2) the LED will be lit green continuously. When a TS 99 preset control is connected this LED can flash green to show a preset preview or a preset in program mode.
  • Page 5: Rear Panel Connectors

    ATTN button again. of the TS-120. After completing your selection of the preset push and hold “Store” until the TS-120 returns to its normal state. User Manual TS 120 / Issue 1 2000 ASL Intercom, Utrecht, Holland.
  • Page 6: Cabling

    Keep cables parallel as much as possible. For interconnecting user stations, power supplies and When two (two channel) units in a network are accessories in an ASL Intercom network, use high connected by more than one cable, make sure that quality shielded two-conductor (minimum 2x 0.30 these cables are parallel to each other over the whole mm2) microphone cable only.
  • Page 7: Guarantee

    WARRANTY 10.0 TECHNICAL SPECIFICATIONS TS-120 POWER CONSUMPTION This unit is warranted by ASL Intercom to the original end- user purchaser against defects in workmanship and materials 45 Watts in it' s manufacture for a period of one year from date of shipment to the end-user.

Table of Contents