In particular, refer to the safety warnings on page 24. INTRODUCTION TECHNICAL DATA The new PAC 36 is a highly versatile electronically- Power supply voltage see rating label controlled air-conditioner: it can be used as a Maximum input power...
Page 3
DESCRIPTION INTERNAL UNIT Connection hose Air outlet grid Control panel Control panel cover EXTERNAL UNIT INTERNAL UNIT Carrying handle ;;;; ;;;; ;;;; ;;;;; ;;;;; ;;;;; ;;;;; ;;;;; Removable filter ;;;; ;;;; ;;;;; ;;;;; ;;;;; Air intake grille Rear panel Power cable Power cable Condensation discharge tube Castors...
Page 4
ACCESSORIES ILLUSTRATION NUMBER SUPPLIED DESCRIPTION Wall bracket Screws + wall plugs (Ø 6mm) Nut and bolt (Ø 5mm) Support belt with hook Frame for connector hose Castor stop Condensation drainage coupling Castors for external unit and washers This appliance is fitted with a special HE (High Efficiency) system for extra-low energy consumption.
In this case, it is necessary to disconnect the INSTALLATION internal unit as follows: MODELS WITHOUT SPECIAL COUPLINGS 1) Remove the plug from the wall socket. The hose which connects the internal unit to the 2) Remove the rear panel (on the back of the external unit can be positioned in two ways: appliance) by unscrewing the four retaining screws.
Page 6
To re-connect the ends of the connector hose to Alternatively, for temporary installation, the the internal unit, repeat steps 1 to 6 in reverse external unit can be hung as shown in the figure. order. The following precautions should be In this case, use the special support belts observed: (supplied with the appliance).
• Draw the curtains and/or partially close the ELECTRICAL CONNECTIONS blinds to protect the room against direct sunlight. Before plugging the unit into the mains, check the This will increase the efficiency and economy following: of the air-conditioner. • the mains voltage must be the same as the •...
CONTROL PANEL Signal lamp indicating 3 min. wait (flashing) or Signal lamp mains (continuous light) or working appliance (on continuously) malfunction (flashing light) ON timer signal lamp Air-cooling signal lamp ON/OFF Timer key Min. speed signal lamp Air-cooling key Fan speed key "SLEEP"...
Page 9
3 - 4 seconds and the AUTO and MAX rature in perfect silence, ensuring that it does not lamps will go out (to modify the power, press the relevant drop excessively. The PAC 36 will only restart if the key). temperature exceeds levels considered healthy.
MAINTENANCE AT THE END OF THE SEASON Switch off the appliance by pressing the ON/OFF key. Always remove the plug from the power Remove the plug from the drainage tube and socket before carrying out any cleaning or empty the water from the internal condensation maintenance operations.
TROUBLESHOOTING Most malfunctions are caused by a very minor and easily solved problem. Before contacting your nearest authorised Service Centre for assistance, consult the troubleshooting chart below. PROBLEM CAUSE SOLUTION • if the pilot lamp is not lit The air-conditioner - power failure •...