Electrical Connections - DeLonghi PAC 30 Instruction Manual

Height of outlet:
within the range indicated by the dotted line in the figure below.
When the unit is not in use, the outlet hole should be sealed with the stopper supplied.
Temporary installation: The outlet holes can be connected in a number of ways:
fixed
hook
In any event, for maximum cooling efficiency the window should be closed as much as possible.
It is advisable :
— to keep the outlet free of any obstruction;
— to lower the blind partly, without obstructing the outlet, thereby reducing exposure to direct sunlight
and indoor/outdoor air exchange.
INSTALLATION FOR HEATING FUNCTION
The unit is simply placed in the room to be heated; there is no need for the discharge hose to be installed.

ELECTRICAL CONNECTIONS

— The mains supply, suitable for domestic electrical appliances, must correspond to the power
requirements of the air conditioner (see rating label).
— Check that the power supply voltage correspond to the voltage shown in the rating label.
— Check that the mains socket is correctly earthed.
N.B.: In the event that the plug supplied with the air-conditioner and complying with European regulations (EEC 7, VII) is not suitable
for your wall socket, make sure that it is replaced with a plug with a capacity of at least 10 A - 250 V (IMQ) that is also suitably earthed.
Remove the power cable from the storage compartment at the back of the unit and plug it into the socket.
THIS APPLIANCE IS MANUFACTURED TO COMPLY WITH THE RADIO INTERFERENCE REQUIRE-
MENTS PROVIDED BY DIRECTIVE EN 55014 EEC.
23