J5create Display Adapter User Manual page 13

USB DISPLAY ADAPTER
A. Connect all external display devices (monitor/ projector) to the
VGA/DVI connector of USB 3.0 Display Adapters and switch power on.
B. Connect the USB 3.0 Display Adapter into an available USB port of a
PC or Notebook.
After Inserting an USB 3.0 Display Adapter into a USB port, the systems
will automatically start the installation procedure and the prompt
message will pop-up on the task bar.
The Device driver software was installed properly,
if you are going to install more USB 3.0 Display Adapters, repeat step A& B
or restart computer.
The functions of the USB 3.0 Display Adapter will be activated after the
computer restarted. You might see the extend display shown on the
display device.
13
USER MANUAL