3-6 Ending Cutting Operations
Ending Cutting Operations
WARNING
WARNING
Procedure
Press the PAUSE/VIEW key to move the tool carriage to a position where the tool and
material can easily be removed.
Move the tool carriage to the inner-right area of the table, make sure operation is stopped,
then remove the material.
If the material is secured by an adhesive sheet or double-sided tape, peel the adhesive sheet off of the
table and store it in a location free from dust.
Remove the tool and put it away.
If the day's operations are finished, remove the cutter, depth regulator nose. Use a dry cloth to wipe away
any grime, cap the cutter, and put it away.
Switch off the power to the EGX-30A.
Close the software application and switch off the computer.
If engraving was performed, vacuum up any cuttings.
38
Chapter 3 Getting Ready for and Performing Cutting
Wash hands when finished.
Wash hands with water to remove any adhering cutting chips.
Use a vacuum cleaner to remove cutting dust. Do not use any blower such as an
airbrush.
Otherwise, dust spread in the air may harm your health or damage the machine.