Electrolux EBSL6 User Manual page 17

The fat trap almost do not need mainte-
nance actions. However, if you frequently
prepare very fatty foods a residues may oc-
cur.
Removing the fat trap:
1. Pull the top heating element out of the
plug connection to the front.
2. Rotate the fat trap to the left from the
oven roof.
3. Wash the fat trap in hot water with wash-
ing-up liquid and soft brush. You can al-
so wash it in dishwasher. With stubborn
dirt, soak for a while in hot water with
soap suds.
4. Insert the fat trap in reverse order. Make
sure the heating element has a good fit
in the connecting socket when inserting.
Removing the heating elements
You can remove the top and bottom heat-
ing elements to clean the oven cavity. In
this case proceed as follows for possible
cleaning actions:
Warning! Ensure that the oven has
cooled down sufficiently so that you
can touch heating elements safely!
There is a risk of burns!
1. Hold the heat element with two hands
at the front.
2. Pull the heating element out of the plug
connection to the front.
3. Reassembly in reverse order. Make
sure the heating element has a good
fit in the connecting socket when in-
serting.
Oven door
To clean the oven door remove it.
Caution! Be careful when you remove
the door from the appliance. The door
is heavy!
Removing the oven door
1. Open the oven door as far as it goes.
2. Lift up clamping levers (A) on the two
door hinges fully.
3. Close the oven door until the first posi-
tion (angle approximately 45°).
electrolux 17