Instructions For The Installer - Electrolux EON21001 User Information

Instructions for the installer

The instructions given below are
designed specifically for a qualified
installer and should aid him or her
to perform all installation,
adjustment, and maintenance
operations with absolute precision
and in compliance with all current
legislation and regulations. We
strongly recommend that all
operations for the installation of
your cooker be carryed out by
Qualified Personnel in accordance
with existing rules and regulations.
Electrical connection
Prior to making the electrical connection,
make sure that:
— the protection fuse and the domestic
wiring system are suitable to carry the
total electric load of the oven (see rating
plate);
— your domestic wiring system has an
efficient earth connection in compliance
with rules and laws in force;
— the wall socket or the omnipole switch
used for the electrical connection can
easily be reached after the oven is built
in.
This appliance is delivered without an
electric supply cable, therefore, you will
have to fit to it a supply cable with
standard plug, suitable for the total
electric load shown on the rating plate.
The plug is to be inserted into a suitable
wall socket. If you require a direct
connection to the electric network
(mains), it will be necessary to fit between
the appliance and the mains an omnipole
switch, with a minimum gap between
contacts of 3 mm, suitable for the required
load and in compliance with rules in
force. The green & yellow ground wire
must not be interrupted by the switch,
and should be 2-3 cm longer than the
phase and neutral wires. The supply
cable must in all cases be laid out in
such a way as to ensure that it does not
reach at any given point a temperature
50°C higher than the ambient
temperature.
Suitable power supply cables are the
following types, considering the
respective necessary section of cable:
H07 RN-F, H05 RN-F, H05 RR-F, H05
VV-F, H05 V2V2-F (T90), H05 BB-F.
electrolux 23