Table of Contents
Advertisement
Using
Using
the
the
Using
Using the
the projector
Starting
up
Starting
Starting up
Starting
up
up
1.Plug the power cable into the projector and into a wall socket. Turn
on the wall socket switch (where fitted) and the power switch on the
projector. Check that the Power indicator on the projector lights red
after power has been applied.
2.Press the
turn the projector on. The projector will be started up immediately.
3.Switch on the connected equipment.
4.Press the SOURCE button on the projector or remote control to
choose the input source you want. See "Switching input signal" on
Page 32 for details.
Note:
Note:
Note:
Note:
If the frequency/resolution of the input signal exceeds the projector's
operating range, it will not operate normally. Please change to an input
signal which is compatible with the projector's resolution or set the
input signal to a lower setting.
Switching
Switching
input
input
Switching
Switching input
input signal
The projector can be connected to multiple equipment at the same
time. However, it can only display one at a time.
Press the SOURCE button repeatedly on the projector or remote
control, then the input source will be changing as the following:
projector
projector
projector
POWER button on the projector or remote control to
signal
signal
signal
33
Advertisement
Table of Contents
