Acomdata Hard Drive Enclosure User Manual page 22

2. With both screws and nuts in place, push down on each
screw head to make sure the screws extend through the
holes as far as they will go.
3. Attach the stand
to the Drive case
by sliding the
nuts through the
groove in the
Drive case, enter-
ing from the backside of the case. The stand is symmetri-
cal so it does not matter which end you insert first. Once
the nuts are in the groove, position the stand so that it is
centered with the Drive case.
3. While holding the stand in place with one hand, use a
screwdriver with the proper type and size head to tighten
the screws. Make sure the stand is firmly secured to the
Drive case.
– 22 –