Electrolux EDE 56160W User Manual page 20

125986670_gb.qxp 2007-02-05
20 electrolux something not working
Malfunction
When pressing a button, the
corresponding button flashes
several times.
Drum light does not
work
Drying cycle ends
shortly after programme
starts. END light illuminated.
Drying cycle lasts an
unusually long time.
Note:
After around 5 hours
the drying cycle ends
automatically (see
„Drying cycle complete")
When a button is pressed, Err
appears in the multi-display.
If you are unable to identify or solve the
problem, contact our service centre.
Before telephoning, make a note of the
model, serial number and purchase date
of your machine: the Service Centre will
require this information.
09:07 Page 20
Possible cause
Washing protection. After the
start of the programme, the
option can no longer be set.
Programme selector in OFF
position.
Defective light bulb
Not enough washing loaded
or washing loaded is too
dry for selected programme.
Lint filter clogged.
button pressed and load
volume too big.
Load volume too big.
Laundry insufficiently
predrained.
Washing protection. After the
start of the programme, the
option can no longer be set.
IMPORTANT: if you call out an engineer
to a fault listed below, or to repair a fault
caused by incorrect use or installation, a
charge will be made even if the
appliance is under guarantee.
Solution
Turn the programme knob to
OFF. Set the programme
again
Turn programme selector to
any programme
Replace light bulb (see next
section).
Select time programme or
higher drying level (e.g. EXTRA
DRY instead of STRONG).
Clean lint filter
is only suitable for use
with loads of up to 3 kg!
Reduce load volume.
Laundry must be adequately
pre-drained.
Turn the programme knob to
OFF. Set the programme again.