A1 Safety Instructions; A2 Copyright - Alpermann+Velte AV-MTD G 30 TTT Operating Manual

Operating Manual AV-MTD G 30 TTT

A1 Safety Instructions

General rules:
Damages in transit:
Positioning:
Maintenance:
Repairs:
EMC:

A2 Copyright

No part of this publication may be reproduced, translated into another language, stored in a
retrieval system, or transmitted, in any form or by any means, electronic, mechanical,
photocopying, recording, or otherwise without the prior written consent of Alpermann+Velte
Electronic Engineering GmbH. Technical changes are reserved. All brand and product names
mentioned herein are used for identification purposes only, and are trademarks or registered
trademarks of their respective holders.
Information in this publication replaces all previously published information. Alpermann+Velte
Electronic Engineering GmbH assumes no responsibility for errors or omissions. Neither is any
liability assumed for damages resulting from the use of the information contained herein.
Whenever it is likely that safe operation is impaired, the instrument must be made inoperative
and secured against unintended operation. The appropriate service authority must then be
informed.
Copyright © Alpermann+Velte Electronic Engineering GmbH 1999-2000. All rights reserved.
For further information please contact your local dealer or:
Alpermann+Velte
Electronic Engineering GmbH
Otto-Hahn-Str. 42
D-42369 Wuppertal
Phone: ++49 - (0)202 – 244 111 0
Fax: ++49 - (0)202 – 244 111 5
info@alpermann-velte.com
E-Mail:
http://www.alpermann-velte.com
Internet:
Only use the device as directed in a dry atmosphere. Treat the AV-
MTD G 30 TTT with the same care as other studio devices. Please
follow the advice in the following operators manual.
If the device shows obvious damages from transit the shipper in
question must be notified and the dealer must be informed.
Position device only where sufficient air circulation can be
maintained. Extreme temperatures, dust, humidity, shocks and
strong electromagnetic fields must be avoided.
Use a moist soft textured fabric cloth when cleaning the housing. Do
not use polish or any other cleaning agents.
The AV-MTD G 30 TTT does not require any extra maintenance.
There are no user serviceable parts inside the device. Repairs should
be sent to an authorized service partner.
The EMC regulations are observed only under the following
condition: use high quality shielded cables at data inputs and
outputs.