Installing The Cabinet - Electrolux ER8509BX Instruction Book

Mounting the handles
Pool handle
1. Screw a handle attachment onto the handle bar.
2. Screw the other handle attachment on the cabinet door.
3. Put the handle with the handle attachment on the door and
screw into place.
Caution! Do not overtighten the screws (max 2 Nm) as you
may damage the door handles.
D-handle
1) Carefully press in the plastic plugs on the opposite side
using a drift.
2) Secure the handle in the plug holes.
3) Then press the supplied plastic plugs into the holes to
which the handle was previously fitted.
Sensa handle
1)Fit the handle onto the opposite side by turning it one half
circle.
2) Press the supplied plastic plugs into the holes to which
the handle was previously fitted.

Installing the cabinet

To otain the best performance from the cabinet, ensure
:
·
the cabinet is placed in a dry, cool place and
is not exposed to direct sunlight.
·
the cabinet is not placed close to a source of
heat, e.g. a cooker or dishwasher.
·
the room in which the cabinet is placed
has a temperature of +16C to +32C.
·
the cabinet is level.The cabinet should not lean
against any wall. If necessary adjust the
feet using the supplied adjustment spanner.
·
there is good air circulation around the cabinet
and that the air channels below and behind
the cabinet are not blocked. The ventilation
space above the cabinet and any
grocery/top cabinet must be at least 200 cm@.
The ventilation space can either be
a) directly above the cabinet, or
b) behind and above the top cabinet. In this case,
the space behind the cabinet must be at least
50 mm deep.
Check that the drain hose at the rear of the cabinet
discharges into the drip tray.
If the cabinet is placed in a corner and the side with
the hinges faces the wall, the distance between the
wall and the cabinet must be at least 10 mm to allow
the door to open enough so that the shelves can be
removed.
.
1
2
a)
29
3
b)
50mm
Electrolux 818 16 10--02/6