Cleaning The Door Glass - Electrolux EOG 660 Instruction Book

4 Using both hands, gently tilt the top of the door glass towards you.
Lift slightly to disengage the locators at the bottom of the door.
5 Clean the outer and inner glass using hot soapy water and mild
abrasives such as 'Jif'.
6 Replace the glass by holding it in both hands and gently placing the
locators into the holes of the brackets at the bottom of the door. Push
the top of the glass towards the oven door, and make sure the screw
location holes line up. Replace the trim on top of the door making
sure that it is correctly positioned. You can check this by looking
through the air gap on the top of the door and checking that the
screw location holes line up.
7 Hold the glass in place with one hand and replace the cross head
screws into the location holes, with the other hand.
8 Tighten the screws using a pozidrive screwdriver.
Close the door.

Cleaning The Door Glass

To prevent damaging or weakening the door glass panels avoid
the use of the following:
Household detergents and bleaches
Impregnated pads unsuitable for non-stick saucepans
Brillo/Ajax pads or steel wool pads
Chemical oven pads or aerosols
Rust removers
Bath/Sink stain removers
If the door glass panel becomes chipped or has deep scratches
the glass will be weakened and must be replaced to prevent the
possibility of the panel shattering. Please contact your local
Service Centre who will be pleased to advise further.
E O G 6 6 0
30