Table of Contents
Advertisement
OPERATION
The slider must immediately be returned to the "0"
position, and then all the other indicators will show "0".
All the heating zones are ready for use but you must
switch your selected zone on within 5 seconds.
If this is not done, the top indicator will indicate a
flashing horizontal line, the hob will then switch off
and you will have to repeat the start-up procedure
again.
If any of the heat control sliders is not in the "0" position,
a horizontal line flashes in the corresponding indicator
and the appliance can not be turned on (fig.5).
Switching on the two-circuit zone
The rear left cooking zone gives the possibility of an
inner and outer section of the heater.
To use the inner section (fig.6), push the slider to the
desired power level.
To use both the inner and outer sections (fig.7), push
the slider to the position indicated by the double circle.
The figure 8 with a dot by it will be shown, it will now be
possible to control both sections with the slider.
To cancel the outer section, return the slider to the "0"
position and then select a power level with the slider,
this will operate only the inner section (fig.6).
Warming zone "L"
If you position the slider slightly above "0", an "L"
appears (fig.9). Now the corresponding cooking zone
can be used as a warming zone.
Special hints:
Child-proof lock
If all power displays show a "0", one cooking zone has
to be switched on within 5 seconds. Otherwise, the
electronic device turns off the ceramic hob.
Safety turn-off
If one cooking zone remains on inadvertently, the elec-
tronical device switches it off automatically after 6
hours. The electronic device turns off the complete
ceramic hob after switching off the last cooking zone.
Switching off the cooking zone
If all sliders are in pos. "0", the electronic device turns off
the hob within 5 seconds.
Rapid turn-off
If it is necessary to turn off the hob as fast as possible
you simply flip up the sliding rail.
8
fig.5
0
fig.6
fig. 8
pos.1
pos.2
0
fig. 9
0
fig.7
Advertisement
Table of Contents
