Table of Contents
Advertisement
INSTALLATION
Warning! Refer to "Safety information"
chapter.
Installing the oven
Warning! Installation into flammable
material must agree with NIN 2005,
chapter 4.2.2 of the VKF (Association
of Cantonal Fire Insurers) fire protection
guidelines and regulations.
1. Pull the appliance drawer out as far as it
goes, take hold of it and remove it.
A
A
A
A
D
A 548
N 550
2. Use the side handles to hold the oven
and slide it flush into the recess.
Caution! Make sure the cable is free
when you slide the appliance.
3. Use at least 2 screws to fix the oven on
both sides (Detail A).
A
4. The enclosed check valve F is screwed
The rear wall must be able to be removed.
ca.50
A
435
Raster: recommended operating ranage.
Electrical connection
Let a qualified electrician connect appliance
to the electricity supply. Use a H05VV-F
type power cable or higher. Install the appli-
ance with a socket supply line, otherwise
the fixed home electrical system must in-
clude an isolating device with at least a 3mm-
contact separation to enable a simultane-
ous and all-pole cut off from the mains (ac-
cording to NIN 2000). The customer must
have a socket for the electrical connection
that is accessible and outside the coordina-
tion room. The length of the connection ca-
ble must be approximately 120 cm with
lines connected direct to the mains.
1. Open the terminal box (detail D).
in to the exhaust air hose. Mount the
check valve F with hose to the appli-
ance (bayonet connection). Exhaust air
temperature: max. 80°C.
A shortened element must be installed
above the oven.
electrolux 21
Advertisement
Table of Contents
