Abit AR5 User Manual page 64

A-6
Installing PS2 Mouse:
cable that comes with the hardware to the connector on the mainboard. Install
the bracket located on the other end of the computer case. When you buy a
Mouse, it has to be a PS/2 Mouse for it to be connected to this port.
Attach the bracket of Parallel Port, Serial Port and PS2 Mouse on the computer
case.
Installing CPU Fan Power connector:
orientation. Connect the three-threads CPU Fan power cable to the Fan
connector on the mainboard.
Pin number
1
2
3
Adjusting other jumpers:
functions or are not to be adjusted in normal operation. Adjust them according to
the following recommendations.
¡G Put jumper on pin 1 and pin 2.
JP6
BIOS Setup:
steps described above and completed the installation, when you power the
computer on, you will see the following message displayed:
TO ENTER SETUP BEFORE BOOT PRESS CTRL-ALT-ESC OR DEL
KEY
Press immediately Del key to enter BIOS Setup. Select Load Setup Defaults,
than enter CPU Soft Menu to set CPU parameters.
J1 - Connect the six-threads PS/2 Mouse
Name of the signal or signification
Ground
+12V
Ground
Some jumpers are reserved for future
Parameters and CPU settings After you have followed the
JP1 - There is a specific
Appendix A