Standby Mode - Abit KG7-RAID User Manual

Introducing the BIOS
There are three options for power management:
! User Define: "User Define" defines the delay for accessing the power modes.

" Standby Mode:

Disabled ) 30 Sec ) 1 Min ) 4 Min ) 10 Min ) 20 Min ) 30 Min ) 1 Hour. The default
setting is Disabled.
" HDD Power Down:
Disabled ) 1 Min ) 2 Min ) 3 Min ) 4 Min ) 5 Min ) 6 Min ) 7 Min ) 8 Min ) 9 Min
) 10 Min ) 11 Min ) 12 Min ) 13 Min ) 14 Min ) 15 Min. The default setting is
Disabled.
When the two saving modes are enabled, the system is set up for minimum or maximum power
savings.
! Min Saving:
Standby Mode: 1 Hour
HDD Power Down = 15 Min
! Max Saving:
Standby Mode: 30 Sec
HDD Power Down = 1 Min
Video Off Method:
Three video off methods are available: "Blank Screen", "V/H SYNC + Blank" and "DPMS Support". The
default is V/H SYNC + Blank.
If this setting does not shut off the screen, select "Blank Screen". If your monitor and video card support
DMPS standard, select "DPMS Support".
Soft-Off by PBTN:
Two items available: Delay 4 Sec or Instant-Off. The default setting is Instant-Off. It is activated when
the user presses the power button for more than four seconds while the system is in the working state,
then the system will transition to the soft-off (Power off by software). This is called the power button
over-ride.
Wake-Up by PCI card (PME):
Two items are available: Disabled or Enabled. The default setting is Disabled. When set to Enabled, any
event occurring to the PCI card will awaken a system that has powered down.
PowerOn by Ring/Lan:
Two items are available: Disabled or Enabled. The default setting is Disabled. When set to Enabled, any
event occurring to the LAN or modem ring will awaken a system that has powered down.
Modem Use IRQ:
Eight items available: NA ) 3 ) 4) 5) 7 ) 9 ) 10 ) 11 ) Back to NA. The default setting is NA.
You can specify the IRQ for modem use.
3-27
User's Manual