Step 3. Installing The Auxiliary Heater Assembly; Step 4. Electrical Wiring - Carrier Air V Owner's Manual

DO NOT USE DUCT TAPE ON OR AROUND FABRIC DUCT COLLAR.
8
Pull fabric tight. This will prevent the material from
gathering inside the discharge duct.
STEP 3 - INSTALLING THE AUXILIARY HEATER ASSEMBLY
1
Place the heater assembly wire (See
existing ceiling assembly screws into the heater assembly guides then slide the heater assembly to the rear
direction. Fasten the heater assembly to the ceiling assembly by using two screws (See
2
Plug the heater assembly electrical harness (See
, Figure 5). Make sure that the "ridged"side of the plug is aligned and matched with the "ridged" side of the
air sweep motor bracket connection. And plug the electrical harness from the upper unit (see
the other one (see
STEP 4 - ELECTRICAL WIRING
ROUTING 115V AC WIRING
MAKE SURE THAT ALL POWER SUPPLY TO THE UNIT IS DISCONNECTED BEFORE PERFORMING ANY WORK ON THE
UNIT TO AVOID THE POSSIBILITY OF SHOCK OR INJURY AND/OR DAMAGE TO THE EQUIPMENT.
, Figure 5) into the hole located on the ceiling assembly. Insert the two
, Figure 5). DO NOT USE EXCESSIVE FORCE (See Figure 5).
WARNING
9
Fasten each side of the fabric duct with fitting
the duct plate to the ceiling assembly plate with
5 screws (See
that may extend beyond edge of duct plate.
, Figure 5) into the back of the air sweep motor bracket (See
<Bottom View>
WARNING
'
OWNER S GUIDE -10
, Figure 4). Trim any excess fabric
, Figure 5).
, Figure 5) into
Figure 5