NetComm NB604N User Manual page 42

Enter the following parameters:
PARAMETER
IPSec Connection Name
Tunnel Mode
Remote IPSec Gateway
Tunnel access from Local
IP Address from VPN
Subnet mask for VPN
Tunnel Access from Remote
IP Address for VPN
Subnet mask for VPN
Key Exchange Method
Authentication Method
Pre-Shared Key
Perfect Forward Secrecy
Advanced IKE Settings
After entering the required IPSec tunnel service settings, click Apply/Save to save the new IPSec Tunnel configuration settings.
YML604X
www.netcommwireless.com
NB604N – ADSL2+ Wireless N300 Modem Router
Enter a name to identify the IPSec tunnel
Select the applicable IPSec tunnel mode
Enter the IP Address of the IPSec server to connect to
Select which remote addresses local IPSec connections are able to access
Enter the IP Address to be used locally for the IPSec tunnel
Enter the subnet mask to be used locally for the IPSec tunnel
Select which local addresses remote IPSec connections are able to access
Enter the IP Address to be used on the remote end for the IPSec tunnel
Enter the subnet mask to be used on the remote end for the IPSec tunnel
Select the type of IPSec exchange is to be used on the IPSec tunnel
Select the applicable authentication for the IPSec tunnel
Enter the pre-shared key (if applicable) to grant access to the IPSec tunnel
Select to use Perfect Forward Secrecy during key exchange for the IPSec tunnel
Configure advanced IKE settings for the IPSec tunnel such as the encryption method or key life time
DEFINITION
NetComm NB604N – ADSL2+ Wireless N300 Modem
42
Router