Master Spas Series Owner's Manual page 42

SPA - CONTROLS: ADJUSTING FILTRATION
TS 6.1 • TS 67.15 • TS 7.1 • TS 7.15
MAIN FILTRATION
Filter cycles are set using a start time and a duration. Start time is indicated by an "A" or "P"
in the bottom right corner of the display. Duration has no "A" or "P" indication. Each setting
can be adjusted in 15-minute increments. The panel calculates the end time and displays it
automatically.
Main Screen
To next item in
Main Menu
FILTER CYCLE 2 - OPTIONAL FILTRATION
Filter Cycle 2 is OFF by default.
It is possible to overlap Filter Cycle 1 and Filter Cycle 2, which will shorten overall filtration by
the overlap amount.
PURGE CYCLES
In order to maintain sanitary conditions, secondary Pumps will purge water from their
respective plumbing by running briefly at the beginning of each filter cycle.
If Filter Cycle 1 is set for 24 hours, enabling Filter Cycle 2 will initiate a purge when Filter
Cycle 2 is programmed to begin.
While the Temperature is
still flashing, press Light
repeatedly until FLTR 1
appears in the LCD.
Shows/flashes start time
to show RUN HRS
to show F1 ENDS xx:xx
Shows/flashes start time
to show RUN HRS
to show F1 ENDS xx:xx
Sets start hour Selects minutes
Sets Filter 1 lenght in hours Selects part of an hour
or
Approx.
30 sec.
Approx.
10 Sec.
OR
Sets start hour Selects minutes
Sets Filter 1 lenght in hours Selects part of an hour
or
Approx.
30 sec.
40
Key
Indicates Flashing or Changing Segment
A temperature button, used for "Action"
Light or dedicated "Choose" button,
depending on control panel configuration
Waiting time - varies depending on function
Sets 15-minute increments
Sets 15-minute increments
Main Screen
Main Screen
Sets 15-minute increments
Sets 15-minute increments
Main Screen
Approx. 30 Sec.
OR
Approx.
30 Sec.
OR
Approx. 30 Sec.
OR
Approx.
30 Sec.
OR