Audio System; System Overview - Polaris Victory Cross Roads Owner's Manual

Table of Contents

Advertisement

Audio System Overview
Audio System Introduction
Not all motorcycles are equipped an audio
system. Motorcycles equipped with an
audio system may not be equipped with all
components discussed in the audio section
of this manual. Components not installed at
the factory can be purchased from and
installed by your VICTORY dealer.
Software Updates
Radio system software should be updated
annually to ensure the best performance.
Please see your authorized VICTORY
dealer for this service.
Radio Frequencies
North America
• AM
520 to 1720 kHz
• FM
87.9 to 107.9 MHz
• WX
162.40 to 162.55 MHz
European
• FM
87.5 to 108.00 MHz
• MW
522 to 1602 kHz
• LW
144 to 288 kHz
Audio Controls
Operation of the audio controls is outlined
in greater detail on the following pages.
U.S.A. Sources
• FM
• AM
• WX
• AUX (NAV MP3, AUX or iPod)
• XM Radio
European Sources
• FM
• MW
• LW
• AUX (NAV MP3, AUX or iPod)
Mode Menu Options
• Bass
• Treble
• Fader
• External Speakers
• Automatic Volume Control • XM Clear Preset
• CB Headset ENT Mode
• ICOM Volume
• CB Volume
104
• CB Local/Distant
• AM/FM Clear Preset
• Radio Data System
• AUX Mode
• XM Display
• XM Category
Audio Controls
3
1. Mode Button: Press and hold the
MODE button until the system enters
the audio system mode menus. Then
press and release the MODE button
until the desired mode menu displays.
Tip: Some mode menu options have sub-menus.
Sources and menu options will be displayed
only for installed components.
2. Tuner Button: Press and release TUNE
(+) or TUNE (-) to change radio stations
or iPod tracks. Press and hold to auto-
matically seek or scan.
3. Volume Button: Press VOL (+) to turn
the audio system on. Press VOL (+) to
increase audio volume. Press VOL (-) to
decrease audio volume. Press and hold
to rapidly increase or decrease volume.
When volume is decreased until "OFF"
displays, continuing to press and hold
VOL (-) for two seconds will turn the
radio off.
4. Memory Preset (PRE) Button: Press
PRE to cycle through the stored preset
locations. See page 108.
2
1
4

Advertisement

Table of Contents
loading

Table of Contents