Hood Surfaces; Light Bulbs; Warming Lamps - GE Monogram ZV30 Owner's Manual

Do not use a steel-wool pad; it will scratch the
Stainless
surface.
steel surfaces
(on some
1. Shake bottle well.
models)
2. Place a small amount of CERAMA BRYTE
3. Clean a small area (approximately 8" x 8"),
4. Dry and buff with a clean, dry paper towel
5. Repeat as necessary.

Light bulbs

The bulbs are located on the underside of
the hood.
To change the light bulbs:
1. Remove the trim ring by turning it
2. Grasp the bulb on the edges and remove
3. Replace with the same type and size bulb.
These 120 volt, 50 watt, par 16 halogen flood
bulbs, with standard base, are available at
specialty lighting stores.
These bulbs can also be ordered from your
GE supplier.
Order bulb no. WB08X10028.
Warming The warming lamps are located on the
underside of the hood.
lamps
These 120 volt, 175 watt, par 38 infrared heat
lamp bulbs, with standard base, are available
at some specialty lighting stores.
These infrared bulbs can also be ordered
from your GE supplier.
Order bulb no. WB08X10029.
8
Stainless Steel Cleaning Polish and
Conditioner on a dry cloth or dry
paper towel.
rubbing with the grain of the stainless steel
if applicable.
or soft cloth.
counterclockwise.
by turning it counterclockwise.
Care and Cleaning
Professional Range Hood
To order:
To order CERAMA BRYTE
Cleaning Polish and Conditioner, please call
our toll-free number:
®
National Parts Center . . . . . . . 800.626.2002
www.GEAppliances.com
CERAMA BRYTE ®
Stainless Steel Cleaning
Polish and Conditioner . . . . . . . # PM10X313
NOTE: If warming lamps are not desired,
additional cooktop lighting can be obtained
by replacing the infrared bulbs with standard
incandescent bulbs with up to 100 watt
maximum ratings, with standard bases. These
bulbs are available at specialty lighting stores.
®
Stainless Steel