Safety Information - Fluke 1750 Calibration Manual

1750
Calibration Manual
To contact Technical Support:
fpqsupport@fluke.com
or 888-257-9897 (US only)

Safety Information

The 1750 Power Recorder (hereafter referred to as the Recorder) complies with
EN 61010-1 600 V CAT IV, 1000 V CAT III overvoltage rating. See Specifications for a
full agency compliance list.
To avoid electrical shock, personal injury, or fire:
2
Review the entire manual before using the Recorder and its
accessories and observe all warnings and cautions.
Do not perform the calibration verification tests or
calibration procedures described in this manual unless you
are qualified to do so.
Avoid working alone.
Do not operate the Recorder around explosive gas or
vapor.
Use only insulated current probes, test leads, and adapters
as supplied with the Recorder, or indicated as suitable for
the Recorder.
Before use, inspect the Recorder, voltage probes, current
probes, leads, and accessories for mechanical damage,
and replace when damaged. Look for cracks or missing
plastic. Pay special attention to the insulation surrounding
the connectors.
Remove all probes, test leads, and accessories that are not
in use.
Make sure the Recorder is properly connected through the
power cord to protective earth ground.
Do not apply input voltages above the rating of the
Recorder as shown on the input panel.
Do not apply voltages in excess of the marked ratings of
the voltage probes and current probes.
Use caution if exposed metal BNC or banana plug
connectors are used for calibration. Avoid applying voltage
to the shell of the BNC during calibration.
Do not insert metal objects into connectors.
Never open the Recorder's enclosure, dangerous voltages
are present. There are no user-replaceable parts in the
Recorder. Refer servicing of internal parts to qualified
service personnel.
Use the Recorder only as specified in this manual, or the
protection provided by the Recorder may be impaired.
XWWarning