Before First Use; Hob - Daily Use - Zanussi ZCV665MN User Manual

Control panel
1 2
6
Accessories
• Deep grill roasting pan
To bake and roast or as pan to collect fat.
• The roasting pan grid

Before first use

Warning! Refer to "Safety information"
chapter.
Initial Cleaning
• Remove all parts from the appliance.
• Clean the appliance before first use.
Caution! Do not use abrasive cleaning
agents! This can damage the surface.
Refer to chapter "Care and Cleaning".
Setting the time
You must set the time before you operate
the oven.
When you connect the appliance to the electri-
cal supply or after a power cut, the indicator for
the Time of Day function flashes.
Press the + or - button to set the correct time.

Hob - Daily use

Warning! Refer to "Safety information"
chapter.
Heat settings
Control knob
Off position
6
3 4 1
5
Function
Knobs for the hob
1
Knob for the top oven functions
2
Electronic programmer
3
Knob for the main oven functions
4
Main oven temperature indicator
5
Top oven temperature indicator
6
To put in the deep roasting pan.
• Oven shelf
For cookware, cake tins, roasts.
After approximately five seconds, the flashing
stops and the display shows the time of day
you set.
To change the time, press
again until the indicator for the Time of Day
function flashes.
Preheating
Set an oven function and maximum temperature
and run an empty oven for 45 minutes, to burn
off any residue from the cavity surface. Acces-
sories can become hotter than in normal use.
During this period an odour can be emitted.
This is normal. Make sure the room is well ven-
tilated.
Preheat the two ovens. Heat up one oven at a
time.
Control knob
Heat settings
1-6 (1 = lowest heat setting; 6=
highest heat setting)
1. Turn the control knob to a necessary heat
setting.
again and
Function
www.zanussi.com