Table of Contents
Advertisement
6. CARE AND CLEANING
Clean the appliance after each use.
Always use cookware with clean bottom.
Scratches or dark stains on the
glass-ceramic cause no effect on
how the appliance operates.
To remove the dirt:
• – Remove immediately: melted plas-
tic, plastic foil, and food with sugar. If
not, the dirt can cause damage to
the appliance.
7. TROUBLESHOOTING
You cannot activate the
appliance or operate it.
An acoustic signal
sounds and the appliance
deactivates.
An acoustic signal
sounds when the appli-
ance is deactivated.
The residual heat indica-
tor does not change col-
ours.
The Automatic Heat Up
function does not oper-
ate.
Problem
– Remove after the appliance is
• The surface of the hob has horizontal
grooves. Clean the appliance with a
moist cloth and some detergent with a
smooth movement from left to right.
• At the end rub the appliance dry with
a clean cloth.
Possible cause
You touched 2 or more
sensor fields at the same
time.
The STOP+GO function
operates.
There is water or fat
stains on the control pan-
el.
You put something on
one or more sensor fields.
The cooking zone is not
hot because it operated
only for a short time.
The cooking zone is hot.
The highest heat setting
is set.
sufficiently cool: limescale rings ,
water rings, fat stains, shiny metallic
discolorations. Use a special cleaning
agent for glass ceramic.
Remedy
Activate the appliance
again and set the heat
setting in less than 10
seconds.
Touch only one sensor
field.
Refer to the chapter "Dai-
ly Use".
Clean the control panel.
Remove the object from
the sensor fields.
If the cooking zone oper-
ated sufficiently long to
be hot, speak to the serv-
ice centre.
Let the cooking zone be-
come sufficiently cool.
The highest heat setting
has the same power as
the Automatic Heat Up
function.
ENGLISH
13
Advertisement
Table of Contents
